doble F6000 - Saving Control Panel Setups; Control Panel Summary

F6000 Family of Power System Simulators User Guide
72A-1589 Rev. C 02/01 4-29
D
DD
D
R
RR
R
A
AA
A
F
FF
F
T
TT
T
3
33
3
/
//
/
5
55
5
/
//
/0
00
0
1
11
1
Saving the F6000 Control Panel Configuration
To save a setup on the Control Panel, click File|Save in the ProTesT
menu bar. To save a setup under a new name, click File|Save As.
ProTesT saves the new information on the Control Panel in an .f6x file.
The default settings for the Control panel are saved in a file named
default.f6x. The Control Panel uses the settings in this file when it first
opens.
Summary
The Control Panel provides full control over each voltage and current
source, and maximum flexibility in preparing for and conducting tests of
protective relays:
• Pre-programmed and user-defined ramp values eliminate manual
errors in testing. The AutoSensE feature simplifies testing and
eliminates errors.
• The phasor diagram shows source table settings in real time and
allows the dragging and dropping of phasors to reset source table
values.
• The Fault Rotate feature makes efficient testing of three-phase
relays possible.
• The eight individual timers enable measurements of eight
different timed events.