z DUPRINTER Installation Instructions
chap.5
256
(5) Setting the master roll
q Grip the top cover release lever, and lift up the
top cover.
w Pull the new master roll out of its bag, and fully
insert the two master holders into the ends of
the new master roll.
* The two master holders are identical.
e Orient the master roll so that the end with the
green line is at the control panel side, and insert
the master roll into the machine.
Top cover
Top cover release lever
Master roll
Green line
t Pull out the master and insert the arrow on the
yellow label until it touch the black rubber
roller.
y Push the master set switch.
The master will be pulled in, and cut
automatically.
If the master does not go in, push the yellow
label slightly back.
r Peel off the seal. Do not peel off the yellow label.
Yellow label
Seal
If the master is wrinkled:push and hold the
master set switch again, and push down the
thermal head escape lever 2 or 3 times.
When the master stops, make sure that you
remove the trimmed piece of the master.
Yellow label
Master set switch
Thermar head escape lever
To Next Page
Loading...
Need help?
General