✽ ✽ ✽
L
¡HELP mode H-01 display
Drum speed (rpm)
✽ ✽ ✽
Ejection belt speed (rpm)
Indicates "Memorizing"
(2)Ejection belt speed adjustment
a
Adjustment of Ejection Belt Speeds 1-5
q
Access HELP mode H-01, and press the PRINT key.
For the basic procedure for accessing HELP modes
When the PRINT key is pressed, the drum will
rotate and the DRUM SPEED (rpm) will be displayed.
w
Use the [<] (DOWN) and/or [>] (UP) print speed adjust
key to select Speed 1.
e
Press the TEXT/PHOTOGRAPH key as many times
as needed to select the TEXT/PHOTOGRAPH item.
r
Use the [<] (DOWN) and/or [>] (UP) print speed adjust
key to adjust the drum speed display reading to 115
rpm.
¡Ejection belt Speed 1 is now set to 115rpm.
t
Press the TEXT/PHOTOGRAPH key to select an
item other than TEXT/PHOTOGRAPH (i.e. to
select the TEXT or the PHOTOGRAPH item).
y
To set Speeds 2 through 5, repeat steps 2) through 5)
above, substituting the appropriate speed for Speed 1
in step 2), and making the appropriate settings given
below.
u
Settings for Speeds 2 through 5:
¡Ejection belt Speed 2: 135rpm
¡Ejection belt Speed 3: 150rpm
¡Ejection belt Speed 4: 175rpm
¡Ejection belt Speed 5: 200rpm
i
Press the STOP key. The drum will stop rotating,
the settings will be memorized, and the HELP mode
selection display will reappear.
a
To Initialize Speed Settings:
q
Access HELP mode H-01, and press the PRINT
key.
For the basic procedure for accessing HELP modes
w
Press the PHOTO DARK key. The adjusted speed
settings will be cleared, and the HELP mode selection
display will reappear.
¡After clearing the settings, be sure to carry out readjustment
of (i.e. make new settings for) ejection belt Speeds 1-5.
NOTE
To Next Page
Loading...
Need help?
General