301
c HELP Mode Function and Operation Procedures
chap.7
1. Functions
(1) Tape cluster function test
(1) Testing the tape cluster's functioning
q
Access HELP mode H-03, and press the PRINT key.
For the basic procedure for accessing HELP modes.
w
Press and hold down the TEST PRINT key. The tape feed motor
will run, and feed out the tape, for as long as the key is held down.
e
Release the TEST PRINT key. The tape cutting solenoid will
be activated, and the tape will be cut.
r
Press the STOP key. The HELP mode selection display will
reappear.
a To exit the HELP mode: Turn the power switch OFF.
a To access another HELP mode: Enter the desired mode number
using the numeric keys.
2. Operation procedure
H-03
(1)Function testingHELP mode
H-03
Mode number flashes
\See page 291
For desccription of operation
\See page 160
To Next Page
Loading...
