325
c HELP Mode Function and Operation Procedures
chap.7
(2) Testing of functioning of single feed and continuous
feed by ADF
q
Access HELP mode H-21, and press the PRINT key.
For the basic procedure for accessing HELP modes.
e
For continuous feed operation: Press the TEST PRINT key.
Paper feed and ejection operations will be executed continuously
until there are no more documents left.
r
Press the STOP key. The HELP mode selection display will
reappear.
a To exit the HELP mode : Turn the power switch OFF.
a To access another HELP mode : Enter the desired mode number
using the numeric keys.
w
For a single feed operation: Press the PLATEMAKING key
once to execute paper feed, and a second time to execute paper
ejection. (Further pressings of the PLATEMAKING key will
execute feed and ejection alternately.)
S
Alarm information is displayed : [
04**
]
H-21
(1) ADF error code display,(2) Function testingHELP mode
04**
Cord Contents and Countermeasures Operation
0403
• No separation
Document detection sensor S1
ON
/
OFF
The separation section stops
immediately.
Operation stops after the previ-
ous document is ejected.
0415
• Document size is not proper.
(2 in 1 mode)
Document detection sensor S1
ON
/
OFF
Operation stop after end of
platemaking and paper ejection.
0421
• The mode which is not in need is
received.
Document detection sensor S1
ON
/
OFF
Alarm information display
H-21
Mode number flashes
\See page 291
To Next Page
Loading...
