332
c HELP Mode Function and Operation Procedures
chap.7
H-28
(1) Adjustment / specification settingHELP mode
1. Functions
(1) Setting of tape cluster presence/absence, buzzer
selection and key card specification
2. Operation procedures
Display Item Setting
0***
Whether there is a tape clus-
ter or not.
There is a tape cluster.
1***
There is not a tape cluster.
*00*
Selecting buzzer.
Standard (Buzzer sounds)
*01*
Buzzer does not sound when trou-
ble occurs.
*10*
Does not sound
*11*
Does not sound
***0
Key card counter specifica-
tions
Keycard counter
***1
No Keycard counter
1001
Initial value
- L -
****
Correction amount display
During memorization:
(1) Setting of tape cluster presence/absence, buzzer
selection and key card specification
q
Access HELP mode H-28, and press the PRINT key.
For the basic procedure for accessing HELP modes.
w
Use the [0] and [1] numeric keys to enter a 4-place binary value for
the desired correction amount. See the table below for 4-place
binary values and the corresponding correction amounts.
r
Press the STOP key. The HELP mode selection display will
reappear.
a To exit the HELP mode : Turn the power switch OFF.
a To access another HELP mode : Enter the desired mode number
using the numeric keys.
e
Press the [=] key. The correction amount will be memorized
in the battery PCB unit's EEPROM. During memorization, "-L-"
will be displayed.
Do not turn off the power before the "-L-" display has disappeared.
IMPORTANT
\See page 291
To Next Page
Loading...
