337
c HELP Mode Function and Operation Procedures
chap.7
H-32
(1) Adjustment / specification settingHELP mode
1. Functions
(1) Selection of first print speed, setting of master
ejection error sensing, selection of sort mode
2. Operation procedures
Display Item Setting
0***
Not used.
1***
*0**
Selecting the first print
speed./Selecting the print
speed for the first sheet after
platemaking is completed.
1st-speed (about 45 rpm)
*1**
JOG speed (about 15 rpm)
**0*
Master mis-ejection detec-
tion
Yes
**1*
No
***0
Selecting sort mode with the
power ON
Non-sort mode
***1
Sort mode
1000
Initial value
- L -
****
Specification setting display
During memorization:
(1) Selection of first print speed, setting of master
ejection error sensing, selection of sort mode
q
Access HELP mode H-32, and press the PRINT key.
For the basic procedure for accessing HELP modes.
w
Use the [0] and [1] numeric keys to enter a 4-place binary value for
the desired correction amount. See the table below for 4-place
binary values and the corresponding correction amounts.
r
Press the STOP key. The HELP mode selection display will
reappear.
a To exit the HELP mode : Turn the power switch OFF.
a To access another HELP mode : Enter the desired mode number
using the numeric keys.
e
Press the [=] key. The correction amount will be memorized
in the battery PCB unit's EEPROM. During memorization, "-L-"
will be displayed.
Do not turn off the power before the "-L-" display has disappeared.
IMPORTANT
\See page 291
To Next Page
Loading...
