Duplo Duprinter DP-43S - Page 336

336
c HELP Mode Function and Operation Procedures
chap.7
H-31
(1) Adjustment / specification settingHELP mode
1. Functions
(1) Setting of number of pre-print sheets
Use this to set a value for the number of pre-print sheets. "Pre-
print sheets" are extra sheets that are printed at the start of
printing, without being added to the print count.
2. Operation procedures
Display
0000
0001
0010
0011
0100
0101
0110
0111
Display
1000
1001
1010
1011
1100
1101
1110
1111
Item
8 sheets
9 sheets
10 sheets
11 sheets
12 sheets
13 sheets
14 sheets
15 sheets
Item
0 sheet(initial value)
1 sheet
2 sheets
3 sheets
4 sheets
5 sheets
6 sheets
7 sheets
- L -
****
Correction amount display
During memorization:
(1) Setting of number of pre-print sheets
q
Access HELP mode H-31, and press the PRINT key.
For the basic procedure for accessing HELP modes.
w
Use the [0] and [1] numeric keys to enter a 4-place binary value for
the desired correction amount. See the table below for 4-place
binary values and the corresponding correction amounts.
r
Press the STOP key. The HELP mode selection display will
reappear.
a To exit the HELP mode : Turn the power switch OFF.
a To access another HELP mode : Enter the desired mode number
using the numeric keys.
e
Press the [=] key. The correction amount will be memorized
in the battery PCB unit's EEPROM. During memorization, "-L-"
will be displayed.
Do not turn off the power before the "-L-" display has disappeared.
IMPORTANT
\See page 291