Duplo Duprinter DP-43S - Page 357

357
c HELP Mode Function and Operation Procedures
chap.7
H-55
(1) Adjustment / specification settingHELP mode
1. Functions
(
1
)
Setting of ink check at printing start, cutting operation
mode for master cutting, and interlocks
2. Operation procedures
Display Item Setting
0***
Setting of ink check, that trig-
gers ink replenishment if no
ink is detected at printing
start
Ink check
1***
No ink check
*0**
Selection of cutter operation
mode
1 stroke = one-way motion
*1**
1 stroke = reciprocating motion
**0*
Interlock: emergency stop if
top cover or ejection box
open
Activated
**1*
Deactivated
***0
Not used
***1
0100
Initial value
- L -
****
Correction amount display
During memorization:
(
1
)
Setting of ink check at printing start, cutting operation
mode for master cutting, and interlocks
qAccess HELP mode H-55, and press the PRINT key.
For the basic procedure for accessing HELP modes.
wUse the [0] and [1] numeric keys to enter a 4-place binary value for
the desired correction amount. See the table below for 4-place
binary values and the corresponding correction amounts.
rPress the STOP key. The HELP mode selection display will
reappear.
a To exit the HELP mode : Turn the power switch OFF.
a To access another HELP mode : Enter the desired mode number
using the numeric keys.
ePress the [=] key. The correction amount will be memorized
in the battery PCB unit's EEPROM. During memorization, "-L-"
will be displayed.
Do not turn off the power before the "-L-" display has disappeared.
IMPORTANT
\See page 291