Duplo Duprinter DP-43S - Page 363

363
c HELP Mode Function and Operation Procedures
chap.7
H-64
(1) Adjustment / specification settingHELP mode
1. Functions
Display
0***
1***
*0**
*1**
**00
**01
**10
**11
Item
Calling up of memory M1 (DP-**S) /
function F1 (DP-**E) data when power
turned on. For when sorter is
connected.
Selection of length of tape
cluster's long tape
Calling up of memory M1 (DP-**S) /
function F1 (DP-**E) data when power
turned on. For when sorter is not
connected.
Setting
OFF: Data not called up
ON: Data called up
OFF: Data not called up
ON: Data called up*1
445mm
395mm
335mm
280mm
(1) Setting of calling up of memory M1 (DP-**S) /
function F1 (DP-**E) data when power turned on
(when sorter present / absent), and length of long
tape for tape cluster
2. Operation procedures
- L -
****
Correction amount display
During memorization:
(1) Setting of calling up of memory M1 (DP-**S) /
function F1 (DP-**E) data when power turned on
(when sorter present / absent), and length of long
tape for tape cluster
qAccess HELP mode H-64, and press the PRINT key.
For the basic procedure for accessing HELP modes.
wUse the [0] and [1] numeric keys to enter a 4-place binary value for
the desired correction amount. See the table below for 4-place
binary values and the corresponding correction amounts.
rPress the STOP key. The HELP mode selection display will reappear.
a To exit the HELP mode : Turn the power switch OFF.
a To access another HELP mode : Enter the desired mode number using the numeric keys.
ePress the [=] key. The correction amount will be memorized
in the battery PCB unit's EEPROM. During memorization, "-L-"
will be displayed.
Do not turn off the power before the "-L-" display has disappeared.
IMPORTANT
\See page 291
*1: When [*1**] is set:
The sorter's power supply must be turned on prior to, or at the
same time as, the DUPRINTER's power supply.