Duplo Duprinter DP-43S - Page 362

362
c HELP Mode Function and Operation Procedures
chap.7
H-63
(1) Adjustment / specification settingHELP mode
1. Functions
Display
0***
1***
*0**
*1**
**0*
**1*
***0
***1
0001
Item
For use in adjustment at
factory
Use of scanner pulley unit
Use of A4 drum
Use of A4 drum can only be
disabled by HELP mode setting
Maximum value for user-set
zoom factor
Setting
OFF: No pulley unit
ON: Pulley unit present
At delivery: *0**
OFF: Use disabled
ON: Use enabled
OFF (300%)
ON (499%)
At shipment
(1) Setting of: use of scanner pulley unit; factory
adjustment value; use of A4 drum: and maximum
value for user-set zoom factor
2. Operation procedures
- L -
****
Correction amount display
During memorization:
(1) Setting of: use of scanner pulley unit; factory
adjustment value; use of A4 drum: and maximum
value for user-set zoom factor
qAccess HELP mode H-63, and press the PRINT key.
For the basic procedure for accessing HELP modes.
wUse the [0] and [1] numeric keys to enter a 4-place binary value for
the desired correction amount. See the table below for 4-place
binary values and the corresponding correction amounts.
rPress the STOP key. The HELP mode selection display will
reappear.
a To exit the HELP mode : Turn the power switch OFF.
a To access another HELP mode : Enter the desired mode number
using the numeric keys.
ePress the [=] key. The correction amount will be memorized
in the battery PCB unit's EEPROM. During memorization, "-L-"
will be displayed.
Do not turn off the power before the "-L-" display has disappeared.
IMPORTANT
\See page 291