Display
0***
1***
*0**
*1**
*10*
*11*
***0
***1
0000
Item
Free rotation is implemented,
to effect tape insertion timing
Selection of duration of free
rotation for tape insertion
timing
Stopping of print operation after
printing of 1 sheet after
platemaking, whether or not
number of sheets to be printed
has been set
Display of list of numbers of
sets and sheets
Setting
OFF
ON
OFF
ON
OFF (free rotation for 3 seconds)
ON (free rotation for 10 seconds)
OFF
ON
At shipment
(1) Selection of: operation stop after printing of 1 sheet
after platemaking; tape insertion timing; and display
of list of numbers of sets and sheets
2. Operation procedures
- L -
****
Correction amount display
During memorization:
(1) Selection of: operation stop after printing of 1 sheet
after platemaking; tape insertion timing; and display
of list of numbers of sets and sheets
qAccess HELP mode H-62, and press the PRINT key.
For the basic procedure for accessing HELP modes.
wUse the [0] and [1] numeric keys to enter a 4-place binary value for
the desired correction amount. See the table below for 4-place
binary values and the corresponding correction amounts.
rPress the STOP key. The HELP mode selection display will
reappear.
a To exit the HELP mode : Turn the power switch OFF.
a To access another HELP mode : Enter the desired mode number
using the numeric keys.
ePress the [=] key. The correction amount will be memorized
in the battery PCB unit's EEPROM. During memorization, "-L-"
will be displayed.
Do not turn off the power before the "-L-" display has disappeared.
IMPORTANT
\See page 291
To Next Page
Loading...
