System Functions 103
How To Turn An Output Off From The Remote Codepad
1.
Enter your
followed by
5
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
2.
Enter the required (1–3) followed by the button.
Two beeps will be heard and the output will now turn off. Repeat step 2 if more than
one output is required to be turned off.
3.
Press the
button again to exit this function.
Two beeps will be heard and the
STAY
and
AWAY
indicators will extinguish.
+
5
+
+ + +
Example
If Output 2 has been programmed as
281000
in “LOCATION 374 – 379”, the
Master Code holder may turn off this output following the steps outlined below;
2580
+
5
+
+
1
+ +
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
