EDM Solution 862 - Changing or Deleting Remote Radio User Codes

Remote Radio Transmitter Operations 69
Changing Or Deleting Remote Radio User Codes
Up to eight remote radio hand held transmitters (User Codes 9 – 16) may be used to operate the
system. Before the control panel will accept any of the signals from any radio remote hand
held transmitter, the control panel must learn the code of the transmitter.
You may substituting the Master Code with the Installer Code if required to perform the
function of changing or deleting remote radio user codes.
How To Add Or Change A Remote Radio User Code
1.
Enter your
followed by
1
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
2.
Enter the
(9-16) that you wish to add or change followed by the
button.
Two beeps will be heard and the corresponding codepad indicators will illuminate.
Refer to "Table 23: Codepad Indicators Showing Relative Remote User Numbers" on
page 70.
3.
Now press any of the
buttons on the hand held transmitter to allow the
control panel to learn the hand held transmitters ID code. Two beeps will be heard and
the
STAY
and
AWAY
indicators will extinguish.
If you wish to add or change any further remote radio user codes, repeat this procedure
as many times as required.
+
1
+
+
+ +
ter
When adding or changing remote radio user codes, this function will automatically
minate if a button is not pressed within sixty seconds or by pressing the button.
One long beep indicates the code entered already exists or an incorrect user number has
been selected.
Electronics Design and Manufacturing Pty Limited ISSUE130