Zone Information 157
Day Alarm Operation
If a zone has been programmed for day alarm, the zone can be isolated in the normal way so
that it does not register as a day alarm zone during the disarmed state. Only zones 1 – 4 can be
used as day alarm zones.
The
STAY
indicator can be programmed to indicate whether day alarm has been turned on or
off. When day alarm has been turned on, the
STAY
indicator will flash once every three
seconds. Refer to Option 8 in “LOCATION 428” on page 219 for more information.
Monitoring of zones 5 – 8 can be achieved by programming an output to mimic a zone. Refer
to Output Event Types on page 192 for more information on all available output types that can
be programmed.
How To Turn Day Alarm On
1.
Hold down the
4
button until three beeps are heard.
How To Turn Day Alarm Off
1.
Hold Down the
4
button until two beeps are heard.
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
