116
Solution 862
Installation Manual
Direct Connect
The direct connect feature has been incorporated giving the installer a simple method for
programming the
Solution 862
control panel at the office or on site visits using a portable
computer. There is no need for telephone lines or modems that makes programming of the
control panel completed easily in minutes.
All that is required is the Direct Link Cable (CC808) connected to the correct serial port on
your IBM or compatible computer and the other end to the auxiliary module socket on the
control panel.
When using the direct connect method of connecting to the control panel, Option 1 in
“LOCATION 180” on page 117/148 does not require to be enabled. The direct connect
method of programming or operating the control panel will operate regardless of this option
being set.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
