EDM Solution 862 - Changing and Deleting User Codes

90
Solution 862
Installation Manual
Changing and Deleting User Codes
This function allows a Master Code holder to add/change or delete any of the system user
codes.
How To Add Or Change A User Code
1.
Enter your
followed by
1
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
2.
Enter the
(1-8) that you wish to change followed by the button.
Two beeps will be heard and the corresponding
ZONE
indicator will illuminate. Refer
to "Table 35: Codepad Indicators Showing Relative User Numbers" on page 91.
3.
Enter the digits required for the
followed by the button.
Two beeps will be heard and the
STAY
and
AWAY
indicators will extinguish.
If you wish to change any further user codes, repeat this procedure as many times as
required.
+
1
+
+
+ + +
1
button is not pr
When adding or changing user codes, this function will automatically terminate if a
essed within sixty seconds or by pressing the button. One long
beep indicates the code entered already exists or an incorrect user number has been
selected.
Example
If you require to program user code number 2 as 4627, follow the steps outlined below and
remember to substitute the default Master Code (2580) with the Master Code that has been
programmed.
2580
+
1
+
+
2
+
+
4627
+
ISSUE130 Electronics Design and Manufacturing Pty Limited