Programming 33
Command 960 - Exit Installer's Programming Mode
This command is used to exit the Installer's Programming Mode after you complete
programming the control panel.
You may exit Installer’s Programming Mode from any location by entering command
960
followed by the
#
button. Two beeps will be heard and the system will return to the
disarmed state. When using the remote codepad to program the system, you will notice that
the
STAY
and
AWAY
indicators will extinguish to indicate that you have terminated Installer’s
Programming Mode.
Command 961- Reset Control Panel Back To Factory Default
Settings
This command will reset the control panel back to the factory default values. Refer to the
default values shown throughout this manual or the programming sheets on pages 245 for more
information.
You may reset the control panel back to the factory default settings from any location when in
Installer’s Programming Mode. This is achieved by entering command
961
followed by
the
#
button. Two beeps will be heard and the system will default back to the factory default
values.
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
