Remote Radio Transmitter Operations 71
Figure 4: 2 Button
and Held Transmitter
(RE012)
2 Channel Radio Remote Hand Held Transmitter Operations
All operations via the 2 button radio remote hand held transmitter are fixed once the control
panel has been taught the hand held transmitters code. Therefore, there is no programming
required for each button of the transmitter.
Arming In AWAY Mode
1.
Press the BLACK button on the hand held transmitter for two seconds.
Two beeps will be heard on the remote codepad and the AWAY indicator will
illuminate. Exit time will now commence.
If horn speaker indication beeps have been enabled, two beeps will be heard from the
horn speaker. If the strobe indications have been enabled, the strobe will flash for 6
seconds to indicate that the system has been armed.
Disarming From AWAY Mode
1.
Press either the BLACK or GREEN button on the hand held transmitter for two
seconds.
Two beeps will be heard on the remote codepad and the AWAY indicator will
extinguish.
If the horn speaker indication beeps have been enabled, one beep will be heard from the
horn speaker. If the strobe indications have been enabled, the strobe will flash for 3
seconds to indicate that the system has been disarmed.
Arming In STAY Mode 1
1.
Press GREEN button on the hand held transmitter for two seconds.
Two beeps will be heard on the remote codepad and the STAY indicator will now
illuminate. Exit time will now commence.
If the horn speaker indication beeps have been enabled, one two-tone beep will be heard
from the horn speaker. If the strobe indications have been enabled, the strobe will flash
for 6 seconds to indicate that the system has been armed.
Disarming From STAY Mode 1
1.
Press either the BLACK or GREEN button on the hand held transmitter for two
seconds.
Two beeps will be heard on the remote codepad and the STAY indicator will
extinguish.
If the horn speaker indication beeps have been enabled, one beep will be heard from the
horn speaker. If the strobe indications have been enabled, the strobe will flash for 3
seconds to indicate that the system has been disarmed.
Panic Alarm
1.
Press both the BLACK button and the GREEN button together for two seconds on the
hand held transmitter. This will initiate an audible panic alarm that will activate the
horn speaker, strobe and internal sirens.
If Option 1 – Enable Codepad Panic To Be Silent has been programmed in “LOCATION
425” on page 216, the remote radio panic alarm will also be silent.
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
