208
Solution 862
Installation Manual
Auto Arming Pre-Alert Timer
LOCATION 413
1
Location Description
413
Increments Of 5 Minutes (0 – 75 Minutes)
Table 115: Auto Arming Pre-Alert Timer Location
This location sets the time period that will warn you before the control panel will automatically
arm in AWAY Mode. The codepad will beep once every second until the pre-alert timer has
expired, after this time, the system will automatically arm itself in AWAY Mode. If you
require the system to automatically arm in STAY Mode 1, enable Option 4 in “LOCATION
428” on page 219.
Once the control panel has automatically armed in AWAY Mode or STAY Mode 1, exit time
will commence. If a valid user code is entered during the pre-alert time, the auto arming time
as programmed in “LOCATION 414 - 417” will extend by one hour.
If you require a programmable output to operate during the auto arming pre-alert time, refer to
Output Event Type – Auto Arm Pre-Arming Alert Time on page 192.
Auto Arming Time
LOCATION 414 - 417
0000
Location Description
414
Actual Hour Of The Day (Tens Digit)
415
Actual Hour Of The Day (Units Digit)
416
Actual Minute Of The Day (Tens Digit)
417
Actual Minute Of The Day (Units Digit)
Table 116: Auto Arming Time Locations
These locations are used to program the actual time of the day that the system will
automatically arm itself in AWAY Mode. This time must be set in 24 hour format (i.e. 10:30
PM would be programmed as 2230). Refer to Option 4 in “LOCATION 428” on page 219 if
you require the system to arm in STAY Mode 1.
If forced arming has been disabled for any zone, the feature of automatic arming will operate
regardless of any zones being unsealed. Refer to Zone Options 2 on page 171 for more
information on programming zones for forced arming.
User code 16 will report when the feature of automatic arming is used.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
