72
Solution 862
Installation Manual
Figure 5: 4 Button
Hand Held Transmitter
(RE013)
4 Channel Radio Remote Hand Held Transmitter Operations
All operations via the 4 channel radio remote hand held transmitter are fixed once the control
panel has been taught the hand held transmitters code. Therefore, there is no programming
required for each button of the transmitter. The DOOR and AUX buttons on the 4-channel
radio remote hand held transmitter may be used to operate programmable outputs (e.g.: garage
door or outside lights etc) on the control panel.
Arming In AWAY Mode
1.
Press the AWAY button on the hand held transmitter for two seconds.
Two beeps will be heard on the remote codepad and the AWAY indicator will
illuminate. Exit time will now commence.
If horn speaker indication beeps have been enabled, two beeps will be heard from the
horn speaker. If the strobe indications have been enabled, the strobe will flash for 6
seconds to indicate that the system has been armed.
Disarming From AWAY Mode
1.
Press either the AWAY or STAY button on the hand held transmitter for two seconds.
Two beeps will be heard on the remote codepad and the AWAY indicator will
extinguish.
If the horn speaker indication beeps have been enabled, one beep will be heard from the
horn speaker. If the strobe indications have been enabled, the strobe will flash for 3
seconds to indicate that the system has been disarmed.
Arming In STAY Mode 1
1.
Press STAY button on the hand held transmitter for two seconds.
Two beeps will be heard on the remote codepad and the STAY indicator will now
illuminate. Exit time will now commence.
If the horn speaker indication beeps have been enabled, one two-tone beep will be heard
from the horn speaker. If the strobe indications have been enabled, the strobe will flash
for 6 seconds to indicate that the system has been armed.
Disarming From STAY Mode 1
1.
Press either the AWAY or STAY button on the hand held transmitter for two seconds.
Two beeps will be heard on the remote codepad and the STAY indicator will
extinguish.
If the horn speaker indication beeps have been enabled, one beep will be heard from the
horn speaker. If the strobe indications have been enabled, the strobe will flash for 3
seconds to indicate that the system has been disarmed.
Panic Alarm
1.
Press both the AWAY button and the STAY button together for two seconds on the
hand held transmitter. This will initiate an audible panic alarm that will activate the
horn speaker, strobe and internal sirens.
If Option 1 – Enable Codepad Panic To Be Silent has been programmed in “LOCATION
425” on page 216, the remote radio panic alarm will also be silent.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
