164
Solution 862
Installation Manual
11
12
13
14
15
Keyswitch Zone
A Keyswitch zone is used when you need to connect a keyswitch to operate the system. Refer
to Keyswitch Zone Options on page 169 for selecting options such as momentary, toggle etc.
User code number 16 will be reported when arming and disarming using this method of
operation. Programming the polarity level of user code 16 will also effect the operation of the
keyswitch zone. Refer to User Code Priority on page 153 for more information.
24 Hour Burglary Zone
A 24 Hour Burglary zone (Contact ID Event Code 133) is always ready to trigger the dialler,
horn speaker, bell and strobe regardless of whether the system is in the armed or disarmed
state. A 24 Hour Burglary zone will not send a restore report until the zone actually restores.
24 Hour Fire Zone
A 24 Hour Fire zone (Contact ID Event Code 110) is always ready to trigger the dialler, horn
speaker, bell and strobe regardless of whether the system is in the armed or disarmed state. A
distinct fire sound is emitted through the horn speaker to indicate this type of alarm condition.
This fire sound is completely different to the burglary sound. A 24 Hour Fire zone will not
send a restore report until the zone actually restores.
Chime Zone
A Chime zone is not a burglary zone. It can never sound the sirens or trigger the dialler. Its
purpose is to map it to a programmable output for an indication of sealed or unsealed state.
Refer to Output Event Type - Global Chime on page 198.
Chime zones require EOL resistors and they will register at a remote codepad. These zones do
not effect the operation of forced arming.
Zone Not Used
If a zone is not used, program it as a zone type of 15. This zone will never sound the sirens or
trigger the dialler. An EOL resistor is not required if this zone type is used.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
