2
22
146
Solution 862
Installation Manual
Dialler Options 2
LOCATION 178
0
Option Description
1
Open/Close Reports Only If Previous Alarm
2
Open/Close Reports For STAY Mode 1 and STAY Mode 2
4
Delay Siren Until Transmission Complete
8
Extend Time To Wait For Handshake From 30 To 55 Seconds
Table 65: Dialler Options 2
Open/Close Reports Only If Previous Alarm
This option requires Open/Close reports in “LOCATION 333 - 334” to be enabled on page 179
1
for it to be effective.
An opening report will be transmitted to the base station receiver when the system has been
disarmed after an alarm has occurred. When the system has been armed, a closing report will
be transmitted. An opening or closing report will not report again until the system has
registered another alarm condition.
2
4
8
If the system is disarmed when an alarm occurs, only a closing report will be transmitted
when the system is next armed.
Open/Close Reports For STAY Mode 1 and STAY Mode 2
If open and close reports are required when the system is armed in STAY Mode 1 or STAY
Mode 2, this option will need to be selected.
This option requires Open/Close reports in “LOCATION 333 - 334” to be enabled on page 179
for it to be effective.
Delay Siren Until Transmission Complete
If this option has been selected, the EDMSAT, horn speaker, bell and strobe outputs will not
activate until the base station receiver has sent a kiss-off back to the control panel after the
message has been transmitted. If multiple messages are transmitted, the sirens will activate
after the last kiss-off has been sent.
However, the EDMSAT, horn speaker, bell and strobe outputs will activate as soon as a
codepad panic, codepad fire and codepad medical alarms have been activated.
Extend Time To Wait For Handshake From 30 - 55 Seconds
The control panel after dialling the monitoring station will wait approximately 30 seconds for
receipt of a valid handshake tone. The handshake tone indicates to the control panel that it has
reached the monitoring station and can now transmit its messages. Enabling this option will
extend the wait time from 30 seconds to 55 seconds.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
