System and Consumer Options 221
Consumer Options 3
LOCATION 430
5
Option Description
1
Codepad Fault Beeps Allowed
2
Use Digit 3 For Codepad Duress Instead Of Digit 9
4
Alarms Activate Sirens and Strobe Outputs In STAY Mode 1 & 2
8
Reserved
1
2
4
8
Table 131: Consumer Options 3
Codepad Fault Alarm Beeps
If this option has been enabled, the codepad will flash the
FAULT
indicator and beep once
every minute until acknowledged when a system fault has occurred. To acknowledge a new
fault and stop the codepad from beeping once every minute, simply press the
button.
If this option has not been enabled, the codepad will only flash the
FAULT
indicator when a
new fault has occurred, but will not cause the codepad to beep once every minute until the fault
has been acknowledged or rectified.
Use Digit 3 For Codepad Duress Instead Of Digit 9
This option if selected, will allow the customer to use the digit
3
after entering their code to
disarm the system to activate a duress alarm.
Alarms Activate Sirens & Strobe Ouputs In STAY Mode 1 & 2
This option will need to be selected if audible alarms are required when the system has been
armed in STAY Mode 1 or STAY Mode 2.
Reserved
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
