92
Solution 862
Installation Manual
Changing and Deleting Remote Radio User Codes
This function allows a Master Code holder to add/change or delete any of the system user
codes.
How To Add Or Change A Remote Radio User Code
1.
Enter your
followed by
1
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
2.
Enter the
(9-16) that you wish to change followed by the button.
Two beeps will be heard and the corresponding codepad indicators will illuminate.
Refer to "Table 36: Codepad Indicators Showing Relative Remote User Numbers" on
page 93.
3.
Now press any of the buttons on the hand held transmitter.
Two beeps will be heard and the
STAY
and
AWAY
indicators will extinguish.
If you wish to change any further user codes, repeat this procedure as many times as
required.
+
1
+
+
+ +
1
ter
When adding or changing remote radio user codes, this function will automatically
minate if a button is not pressed within sixty seconds or by pressing the button.
One long beep indicates the code entered already exists or an incorrect user number has
been selected.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
