1
2
3
4
5
6
7
8
System Functions 91
How To Delete A User Code
1.
Enter your followed by
1
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
2.
Enter the (1-8) that you wish to delete followed by the button.
Two beeps will be heard and the corresponding
ZONE
indicator will illuminate. Refer
to "Table 35: Codepad Indicators Showing Relative User Numbers" on page 91.
3.
Press the
button to delete the user code.
Two beeps will be heard and the
STAY
and
AWAY
indicators will extinguish.
If you wish to delete any further user codes, repeat this procedure as many times as required.
+
1
+
+ + +
When deleting user codes, this function will automatically terminate if a button is not
pressed within sixty seconds or by pressing the button. One long beep indicates
an incorrect user number has been selected.
User
No
Zone 1
Indicator
Zone 2
Indicator
Zone 3
Indicator
Zone 4
Indicator
Zone 5
Indicator
Zone 6
Indicator
Zone 7
Indicator
Zone 8
Indicator
V
V
V
V
V
V
V
V
Table 35: Codepad Indicators Showing Relative User Numbers
Example
If you wish to delete user code number 3, follow the steps outlined below and remember to
substitute the default Master Code (2580) with the Master Code that has been programmed.
2580
+
1
+
+
3
+
+
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
