58
Solution 862
Installation Manual
Disarming The System From STAY Mode 2
There are two methods for disarming the system from STAY Mode 2. Method one is standard
and will always operate. Method two is optional and needs Option 4 to be enabled in
"LOCATION 429" on page 220.
Method two will not operate unless both Option 2 and Option 4 has been enabled in
"LOCATION 429" on page 220.
Method One
How To Disarm The System From STAY Mode 2
1.
Enter your
followed by the button.
Two beeps will be heard and the
STAY
indicator will extinguish. The system is now
disarmed.
+
Method Two
A flashing
ZONE
indicator represents a previous alarm on that zone. If this is the case a valid
user code will need to be used to disarm the system using method one. To enable method two,
Option 4 in "LOCATION 429" on page 220 will need to be programmed.
How To Disarm The System From STAY Mode 2
1.
Hold down the
0
button until two beeps are heard.
The
STAY
indicator will extinguish and the system is now disarmed.
0
Single button disarming from STAY Mode 2 will report as user code number 16.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
