EDM Solution 862 - Setting up and Programming Domestic Reporting

Domestic Dialling 121
Setting Up and Programming Domestic Reporting
Programming the control panel for domestic reporting has been made extremely simple by the
use of the Installer's Programming Command 965. Refer to Command 965 - Set Up Domestic
Dialling Format on page 37 for more information.
How To Set Up The Control Panel For Domestic Dialling
1.
Enter Installer's Programming Mode (EG:
1234
followed by the button).
Two beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
2.
Enter Command
965
followed by the button.
Two beeps will be heard. The control panel has now been set up for Domestic Dialling
Format. Refer to Command 965 - Set Up Domestic Dialling Format on page 37 for
more information.
3.
Exit Installer's Programming Mode by entering Command
960
followed by the
button. Two beeps will be heard and the
STAY
and
AWAY
indicators will
extinguish. The system will now return to the disarmed state.
4.
Enter your
followed by
2
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
If there are telephone numbers programmed, they will be displayed one digit at a time
via the codepad indicators.
If there are no telephone numbers programmed, a further two beeps will be heard after
entering this mode. These two beeps are normally heard after the last digit of the last
phone number has been displayed.
5.
Enter all the digits for
, one digit at a time. You will notice as each digit is
entered, the corresponding codepad indicators will illuminate.
6.
If there is more than one telephone number, press the
button followed by the
4
button after the last digit of the telephone number. This will insert a break between the
first telephone num
ber and the second telephone number. If there is only one telephone
number, press the
button to exit this mode.
7.
Enter all the digits for
, one digit at a time. You will notice as each digit is
entered, the corresponding codepad indicators will illuminate.
8.
After the last digit of the second telephone number, press the
button to exit this
mode unless a third telephone number is required. If there is a third telephone number
to be programmed, press the
button followed by the
4
button to insert a break
between the second telephone number and the third telephone.
+
2
+
+
+ +
4
+ +
Electronics Design and Manufacturing Pty Limited ISSUE130