EDM Solution 862 - System Date

System Event Timers 211
System Date
LOCATION 905 – 910
010101
Location Description
905
Day Of The Month (Tens Digit)
906
Day Of The Month (Units Digit)
907
Month Of The Year (Tens Digit)
908
Month Of The Year (Units Digit)
909
Year (Tens Digit)
910
Year (Units Digit)
Table 121: System Date Locations
The
Solution 862
control panel has a real time 12 month calendar that needs to be set
during installation. This time must be set using the format DDMMYY (i.e. If the date that is
required to be set is the 1 July 1997, you would then program 010797). Every time the system
has been powered down, the system date will need to be reset.
Setting The Date and Time
The Master Code holder is allowed to set the date and time as follows:
How To Set The New Date and Time
1.
Enter your followed by
6
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
2.
Enter the day, month, year, hour and minute using the (DD, MM, YY, HH, MM) format
(i.e. DD = Day of the month, MM = Month of the year, YY = Current year, HH = Hour
of the day, MM = Minute of the day).
Please note that when programming the hour of the day, you will need to use 24:00 hour
format.
3.
Press the
button when finished.
Two beeps will be heard and the
STAY
and
AWAY
indicators will extinguish. If a long
beeps is heard, an error was made when entering the date and time.
Example
If the date and time needs to be set for the 1st January 1997 at 10:30 PM, program the date and
time as follows;
2580
+
6
+
0
+
1
+
0
+
1
+
9
+
7
+
2
+
2
+
3
+
0
+
Electronics Design and Manufacturing Pty Limited ISSUE130