Programming 31
Command 959 - Test Programming Key
This command initiates a test to be carried out on the programming key. Only the
Programming Key (CC891) may be used with the
Solution 862
control panel.
The programming key test is non-destructive and any data in the programming key will remain
intact after the test has been completed. One long beep indicates that the programming key test
has failed and two beeps indicates a successful test.
If the programming key has been removed before the test is complete or the programming key
has failed, the data in the programming key has become corrupt. Remember not to remove the
programming key while the activity LED is constantly illuminated or pulsing rapidly.
How To Test The Programming Key
1.
Enter Installer's Programming Mode (i.e.
1234
followed by the
#
button).
Two beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash on the
remote codepad to indicate that you have entered Installer’s Programming Mode. You
will also notice that the remote codepad will display the data currently programmed in
“LOCATION 000”.
2.
Plug the programming key onto the pins marked PROGRAMMING KEY on the control
panel found at the top of the PCB (printed circuit board) next to the Auxiliary Module
socket.
3.
Enter command
959
followed by the
#
button.
Two beeps will be heard after the programming key has successfully been tested. If you
heard a long beep after issuing this command, the programming key has become corrupt
and will need to be erased to clear the corrupt data. Refer to Command 964 - Erase
Programming Key on page 36 for more information.
4.
Before removing the programming key from the control panel, enter command
960
followed by the
#
button to exit the Installer's Programming Mode. Two
beeps will be heard. The
STAY
and
AWAY
indicators will now extinguish on the remote
codepad and the system will return to the disarmed state.
Failing to exit Installer’s Programming Mode before removing the programming key
may result in corrupting the data in the programming key.
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
