32
Solution 862
Installation Manual
How To Test The Programming Key Using The Hand Held Programmer
1.
Before connecting the hand held programmer onto the pins marked PROGRAMMING
KEY, make sure that the switch on the hand held programmer is in the EXT position
and that no external key has been plugged onto the hand held programmer.
2.
Enter the Installer's Programming Mode (i.e.
1234
followed by the
#
button).
Two beeps will be heard and the hand held programmer will display the data currently
programmed in “LOCATION 000”.
3.
Plug the programming key onto the pins marked EXTERNAL KEY on the hand held
programmer.
4.
Enter command
959
followed by the
#
button.
Two beeps will be heard after the programming key has successfully been tested. If you
heard a long beep after issuing this command, the programming key has become corrupt
and will need to be erased to clear the corrupt data. Refer to Command 964 - Erase
Programming Key on page 36 for more information.
5.
Before removing the programming key from the hand held programmer, enter command
960
followed by the
#
button to exit the Installer's Programming Mode. Two
beeps will be heard and the system will now return to the disarmed state.
Failing to exit Installer’s Programming Mode before removing the programming key
may result in corrupting the data in the programming key.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
