Zone Information 163
2
3
4
5
6
7
8
9
10
Delay-1 Zone
A Delay-1 zone (Contact ID Event Code 130) will have a delay time determined by the value
in Entry Timer 1 on page 204. After entry time has expired, the system will activate into alarm
condition.
If a Delay-1 zone has not restored at the time the system is disarmed, a zone restore report will
be automatically sent to the receiving party.
Delay-2 Zone
A Delay-2 zone (Contact ID Event Code 130) will have a delay time determined by the value
in Entry Timer 2 on page 204. After entry time has expired, the system will activate into alarm
condition.
If a Delay-2 zone has not restored at the time the system is disarmed, a zone restore report will
be automatically sent to the receiving party.
Reserved
Reserved
24 Hour Medical
A 24 Hour Medical zone (Contact ID Event Code 100) is always ready to trigger the dialler,
horn speaker, bell and strobe regardless of whether the system is in the armed or disarmed
state. A medical report will be transmitted to the base station receiver. A 24 Hour Medical
zone will not send a restore report until the zone actually restores.
24 Hour Panic
A 24 Hour Panic zone (Contact ID Event Code 120) is always ready to trigger the dialler, horn
speaker, bell and strobe regardless of whether the system is in the armed or disarmed state. A
panic report will be transmitted to the base station receiver. A 24 Hour Panic zone will not
send a restore report until the zone actually restores.
24 Hour Hold-Up
A 24 Hour Hold-Up zone (Contact ID Event Code 122) is always ready to trigger the dialler,
horn speaker, bell and strobe regardless of whether the system is in the armed or disarmed
state. If you require the hold-up alarm to be silent, enable Option 4 – Silent Alarm in Zone
Options 1 on page 167. A 24 Hour Hold-Up zone will not send a restore report until the zone
actually restores.
24 Hour Tamper
A 24 Hour Tamper zone (Contact ID Event Code 137) is always ready to trigger the dialler,
horn speaker, bell and strobe regardless of whether the system is in the armed or disarmed
state. A 24 Hour Tamper zone will not send a restore report until the zone actually restores.
Reserved
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
