172
Solution 862
Installation Manual
Zone Reporting Information
Zone Report Code
If you wish the control panel to transmit zone alarm reports, this location should be
programmed as 1. If you do not wish to transmit zone alarm reports, this location should be
programmed as a 0.
Zone Dialler Options
This location is factory default to report only to receiver 1. You can select each zone to report
on receiver 1, receiver 2, both receiver 1 and receiver 2, receiver 2 only when receiver 1 fails
or no reporting at all. Select the required dialler option from the table below.
Option Description
0
No Report Required
1
Receiver 1
2
Receiver 2
4
Receiver 1 and Receiver 2
8
Receiver 2 Only When Receiver 1 Fails
Table 77: Zone Dialler Options
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
