66
Solution 862
Installation Manual
AC Mains Failure
An AC mains supply failure will automatically flash the
MAINS
indicator. If the AC mains
supply has been disconnected continuously for more than two minutes, the remote codepad
will beep the codepad buzzer once every minute. If the control panel has been programmed to
report an AC mains fail to a base station receiver,”AC Fail" report (Contact ID Event Code
301) will be transmitted.
The
MAINS
indicator will cease to flash as soon as the AC mains supply has been reconnected.
When the AC mains supply has been continuously connected for a period of two minutes, the
codepad will cease the once a minute beep and”AC Fail” restore report will be transmitted to
the base station receiver.
If Option 1 – Enable AC Fail In 1 Hour in “LOCATION 426” on page 217 has been enabled,
the codepad will flash the
MAINS
indicator as soon as the AC mains supply has been
disconnected and will not activate the dialler or the codepad buzzer unless the AC mains
supply has been disconnected continuously for a period of 1 hour.
If Option 2 – Ignore AC Mains Fail in “LOCATION 426” on page 217 has been enabled, the
codepad will not indicate when the AC mains supply has failed, but the control panel will still
report if enabled an "AC Fail" report.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
