EDM Solution 862 - System Functions

76
Solution 862
Installation Manual
System Functions
This section explains the more advanced features that are required for testing and regular
maintenance of the system. Features such as Installer Code Functions, Master Code Functions
and Hold Down Functions are covered in this section.
Installer Code Functions
Installer Code Functions are designed to allow the installer to perform various system tests
without the need to know a Master Code.
To enter the required Installer Code function, enter the followed by the
required digit and the button. All available Installer Code functions are listed
in “Table 25: Installer Code Functions” outlined below.
+ +
These functions can only be carried out when the system is in the disarmed state.
Function
Description Page
0
Reserved
1
Set Number Of Days Until The First Test Report 77
2
Change Domestic Telephone Numbers 78
3
Change Telco Arm/Disarm Sequence 80
4
Setting STAY Mode 2 Zones 85
5
EDMSAT - Satellite Siren Service Mode 86
6
Turning Telephone Monitor Mode On/Off 87
7
Walk Test Mode 87
8
Event Memory Recall Mode 88
9
Reserved
Table 25: Installer Code Functions
Reserved
0
ISSUE130 Electronics Design and Manufacturing Pty Limited