EDM Solution 862 - Dialler Options 3

Dialler Options 147
Dialler Options 3
LOCATION 179
0
Option Description
1
Set DTMF Dialling Pulses To 1 Digit/Second
2
Reserved
4
Change Decadic Dialling To 60/40
8
Reserved
1
2
4
8
Table 66: Dialler Options 3
Set DTMF Dialling Pulses To 1 Digit/Second
If this option is not selected, the dialling format – Australian DTMF dials at the rate of 5 digits
per second (i.e. 100 ms tone, 100 ms pause, 100 ms tone, 100 ms pause).
If this option has been selected, the dialling format – Australian DTMF dials at the rate of 1
digit per second (i.e. 500 ms tone, 500 ms pause).
Reserved
Change Decadic Dialling To 60/40
Some countries have different requirements for decadic dialling. Setting this option will
change the dialling characteristics from 65/35 (Australian Standard) to 60/40. This option
should only be set when the control panel is used in a country that requires decadic dialling as
60/40. This option has no effect when using DTMF tone dialling.
Reserved
Electronics Design and Manufacturing Pty Limited ISSUE130