68
Solution 862
Installation Manual
Remote Radio Transmitter Operations
The
Solution 862
control panel has the ability to be remotely operated using hand held
radio remote transmitters. There is a choice of using either a 2 channel hand held transmitter or
a 4 channel hand held transmitter to operate the system.
Both the 2 channel and 4 channel hand held transmitters can remotely arm and disarm the
system in AWAY Mode or STAY Mode 1 and activate remote panic alarms. However, the 4
-
channel hand held transmitter has the added ability to operate the control panels programmable
outputs allowing you to activate a garage door or outside lights etc.
Before any hand held radio transmitter can operate the control panel, you will need to teach the
control panel the transmitters radio code. Refer to Changing Or Deleting Remote Radio User
Codes on page 69 for more information.
Indications Upon Remote Radio Transmitter Operations
When using either the 2 channel or 4 channel hand held transmitters to operate the system,
audible and/or visual indications can be provided via the horn speakers or the strobe. This will
allow you to operate the system from outside the premises with confidence. Only the installer
can program the feature of audible and/or visual indication beeps. Refer to Option 4 – Allow
Strobe Indications For Radio Arm/Disarm and Option 8 – Allow Horn Speaker Beeps For
Radio Arm/Disarm in “LOCATION 424” on page 215 for more information.
No Of Beeps System Status
1
System Disarmed
2
System Armed In AWAY Mode
1 Two Tone
Beep
System Armed In STAY Mode 1
Table 21: Horn Speaker Indication Beeps For Remote Operations
Strobe Duration System Status
3 Seconds
System Disarmed
6 Seconds
System Armed In AWAY Mode
6 Seconds
System Armed In STAY Mode 1
Table 22: Strobe Indications For Remote Operations
Remote Radio User Code Priority Levels
The radio remote hand held transmitters may only be programmed to operate as user codes 9 –
16. Priority levels can be allocated to each radio remote hand held transmitter, allowing the
transmitter to only arm the system, arm and disarm the system etc. Refer to User Code Priority
on page 153 for more information.
Before any hand held radio transmitter can operate the control panel, you will need to teach the
control panel the transmitters radio code. Refer to Changing Or Deleting Remote Radio User
Codes on page 69 for more information.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
