150
Solution 862
Installation Manual
Access Codes
This section describes the access codes that are used to assign privileges and access functions
for user code holders of the system. Two types of user codes exist within the system, the
Installer Code and User Codes. Each of these codes allow specific access and operation of the
varied functions of the control panel.
Installer Code
LOCATION 181 - 184
1234
This code is used to access the Installer's Programming Mode and can be between one to four
digits long. However, after the control panel has been powered up, the Installer Code can
disarm the system if it is the first code used. The next time the Installer Code is used, access
into Installer's Programming Mode will be made.
Installer Code functions are available to allow the installer to carry out various functions
during the disarmed state without the need to remember the customers Master Code. Refer to
Installer Code Functions on page 76 for more information.
Refer to Programming With The Remote Codepad on page 23 or Programming With The Hand
Held Programmer on page 25 for more information on programming the system.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
