System Functions 105
7
Walk Test Mode
Walk test mode allows you to test detection devices to ensure that they are functioning
correctly. Before activating walk test mode, isolate any zones that are not required for testing.
Refer to Isolating Zones on page 60 for further information.
How To Enter Walk Test Mode
1.
Enter your
followed by
7
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash. The
codepad will beep once every second while the system is in walk test mode.
2.
Unseal and seal the zones to be tested.
The codepad will sound one long beep and the horn speaker will sound one short beep
every time a zone is sealed or unsealed.
3.
Press the
button to exit this function.
Two beeps will be heard and the
STAY
and
AWAY
indicators will extinguish. The
system has now returned to the disarmed state.
+
7
+
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
