System Functions 87
Turning Telephone Monitor Mode On/Off
6
Telephone monitor mode allows the remote codepad to be used for a visual representation of
data transmissions between the control panel and the base station receiver. The dialling
sequence is also shown in this mode.
The codepad will beep once every two seconds while telephone monitor mode active
regardless of whether the system is in Installer's Programming Mode or normal operating
mode. The first five indicators are used to display the progressive steps for a transmission to
the base station receiver.
Zone Indicator Dialling Event
1
Telephone Line Seized
2
Dialling Phone Number
3
Handshake Received
4
Data Is Being Transmitted
5
Kiss-Off Received
None
Telephone Line Released
7
Table 30: Telephone Monitor Mode Indications
How To Turn Telephone Monitor Mode On
1.
Enter your followed by
6
and the button.
Three beeps will be heard.
How To Turn Telephone Monitor Mode Off
1.
Enter your followed by
6
and the button.
Two beeps will be heard.
+
6
+
Walk Test Mode
Walk test mode allows you to test detection devices to ensure that they are functioning
correctly. Before activating walk test mode, isolate any zones that are not required for testing.
Refer to Isolating Zones on page 60 for further information.
How To Enter Walk Test Mode
1.
Enter your followed by
7
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash. The
codepad will beep once every second while the system is in walk test mode.
2.
Unseal and seal the zones to be tested.
The codepad will sound one long beep and the horn speaker will sound one short beep
every time a zone is sealed or unsealed.
3.
Press the
button to exit this function.
Two beeps will be heard and the
STAY
and
AWAY
indicators will extinguish. The
system has now returned to the disarmed state.
+
7
+
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
