Programming 29
Installer’s Programming Commands
There are ten different commands that can be used to perform various functions once the
Installer's Programming Mode has been entered. To issue the command required, enter the
corresponding numerical code followed by the
#
button.
Command Description Page
958
Enable/Disable Zone Status Mode 30
959
Test Programming Key 31
960
Exit Installer’s Programming Mode 33
961
Reset Control Panel Back To Factory Default Settings 33
962
Copy The Control Panel Memory To The Programming
Key
34
963
Copy The Programming Key Data To The Control
Panel
35
964
Erase Programming Key 36
965
Set Up Domestic Dialling Format 37
966
Enable/Disable Automatic Stepping Of Locations
During Programming
38
999
This Command Displays The Control Panel’s Software
Version Number Or Control Panel Type
40
Table 5: Installer's Programming Commands
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
