EDM Solution 862 - Command 963 - Copy from Programming Key to Control Panel

Programming 35
Command 963 - Copy From Programming Key To Control Panel
This command is used to copy data from the programming key to the control panel. Only the
Programming Key (CC891) may be used with the
Solution 862
control panel.
How To Copy The Programming Key Memory To The Control Panel
1.
Enter Installer's Programming Mode (i.e.
1234
followed by the
#
button).
Two beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash on the
remote codepad to indicate that you have entered Installer’s Programming Mode. You
will also notice that the remote codepad will display the data currently programmed in
“LOCATION 000”.
2.
Connect the programming key onto the pins marked PROGRAMMING KEY on the
control panel found at the top of the PCB (printed circuit board) next to the Auxiliary
Module socket.
3.
Enter command
963
followed by the
#
button.
Two beeps will be heard after the programming key's data has successfully been copied
into to the control panel. If you heard a long beep after issuing this command, the
programming key has become corrupt and will need to be erased to clear the corrupt
data. Refer to Command 964 - Erase Programming Key on page 36 for more
information.
4.
Before removing the programming key from the control panel, enter command
960
followed by the
#
button to exit Installer's Programming Mode. The
STAY
and
AWAY
indicators will now extinguish on the remote codepad and the system will
return to the disarmed state.
Failing to exit Installer’s Programming Mode before removing the programming key
may result in corrupting the programming key.
How To Copy Programming Key Memory To Control Panel Using Hand Held Programmer
1.
Before connecting the hand held programmer onto the pins marked PROGRAMMING
KEY, make sure that the switch on the hand held programmer is in the EXT position
and that no external key has been plugged onto the hand held programmer.
2.
Enter Installer's Programming Mode (i.e.
1234
followed by the
#
button).
Two beeps will be heard and the hand held programmer will display the data currently
programmed in “LOCATION 000”.
3.
Plug the programming key onto the pins marked EXTERNAL KEY on the hand held
programmer.
4.
Enter command
963
followed by the
#
button.
Two beeps will be heard after the programming key's data has successfully been copied
into to the control panel. If you heard a long beep after issuing this command, the
programming key has become corrupt and will need to be erased to clear the corrupt
data. Refer to Command 964 - Erase Programming Key on page 36 for more
information.
5.
Before removing the programming key from the hand held programmer, enter command
960
followed by the
#
button to exit Installer's Programming Mode. Two beeps
will be heard and the system will now return to the disarmed state.
Failing to exit Installer’s Programming Mode before removing the programming key
may result in corrupting the programming key.
Electronics Design and Manufacturing Pty Limited ISSUE130