System Reporting Information 179
Open/Close Reports
LOCATION 333 - 334
Location Description
333
Opening Report
334
Closing Report
Table 84: Open/Close Reporting Locations
An "Opening" report (Contact ID Event Code 401) will be transmitted to the base station
receiver when the system has been disarmed from AWAY Mode. A "Closing" report (Contact
ID Event Code 401) is transmitted at the end of exit time when the system has been armed in
AWAY Mode.
If an expanded format has been selected, this code will be used as the expansion code and the
user number that armed or disarmed the system will follow in the same transmission.
Refer to Option 2 in "LOCATION 178" on page 146 for programming "Open/Close" reports in
STAY Mode. To program "Open/Close" reports only after a previous alarm, refer to Option 1
in "LOCATION 178" on page 146.
If you do not require "Open/Close" reports, program "LOCATION 333 - 334" with zero.
Open/Close Reporting Options
LOCATION 335
Option Description
0
No Report Required
1
Receiver 1
2
Receiver 2
4
Receiver 1 and Receiver 2
8
Receiver 2 Only When Receiver 1 Fails
Table 85: Open/Close Reporting Options Location
This location is factory default to report only to receiver 1. You can select whether the
open/close reports will report on receiver 1, receiver 2, both receiver 1 and receiver 2, receiver
2 only when receiver 1 fails or no reporting at all.
Electronics Design and Manufacturing Pty Limited ISSUE130
1
To Next Page
Loading...
