60
Solution 862
Installation Manual
Isolating Zones
Isolating zones allow you to manually disable one or more zones before arming the system in
AWAY Mode, STAY Mode 1 or STAY Mode 2. Once a zone has been isolated, access is
allowed into that zone during the armed state without activating the sirens or dialler.
An example when you may require to isolate a zone before arming in AWAY Mode, STAY
Mode 1 or STAY Mode 2 may be when a zone PIR detector may be false alarming or that you
may need to leave a pet inside a particular zone whilst you are away.
Isolating zones is performed by one of two methods. One way requires the use of a valid user
code while the other way does not. The ability to isolate zones is governed by the priority level
allocated to each user code holder. Some user code holders may not be able to isolate zones.
Refer to User Code Priority on page 153 for further information.
Zones that have been manually isolated using this method will transmit a zone bypass report
(Contact ID Event Code 570) for each zone upon arming the system. A zone bypass restore
report will be transmitted when the system has been disarmed.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
