EDM Solution 862 - Code to Isolate

62
Solution 862
Installation Manual
Code To Isolate
The method of code to isolate restricts only those user codes that have the priority level Code
To Isolate set to be able to isolate zones. Therefore, if any user code has this priority level set,
the method of standard isolating will be disabled.
1.
Press the
button.
2.
Enter your
.
3.
Press the
button.
Three beeps will be heard and the
STAY
indicator will begin to flash. If you attempt to
enter isolating mode with a user code that has not been allocated for code to isolate, the
system will ignore the attempt to enter the mode.
4.
* Enter the
required to be isolated followed by the button. The
zone you have just selected to be isolated will now begin to flash.
24 hour zones will automatically isolate as soon as the
button has been pressed.
All other burglary zones will automatically isolate only after the system has been
armed.
Repeat Step 4 if more than one zone is required to be isolated until all zones that are
required to be isolated have been selected.
5.
Press the
button when finished selecting the zones to be isolated.
Two beeps will be heard and the system will return to the disarmed state.
The zones selected to be isolated when you arm the system in AWAY Mode, STAY Mode 1 or
STAY Mode 2 will continue to flash until the system has next been disarmed.
+ +
+
+ +
*
As each zone is selected to be isolated, the corresponding ZONE indicator will begin
to flash. If a mistake
is made, press the zone number that was incorrectly entered
followed by the button. This zone is now no longer selected to be isolated and
the ZONE indicator will extinguish.
Example
If you wish to manually isolate zones 1, 3 and 4, the following sequence would be entered
below;
+ +
+
1
+ +
3
+ +
4
+ +
ISSUE130 Electronics Design and Manufacturing Pty Limited