180
Solution 862
Installation Manual
Codepad Duress Report
LOCATION 336
6
Location Description
336
Codepad Duress Report
Table 86: Codepad Duress Report Location
A "Duress" report (Contact ID Event Code 121) will be transmitted to the base station receiver
when the
9
button is added to the end of any valid user code being used to disarm the system.
This alarm will always be silent. A duress alarm can be triggered during exit time (i.e. If the
system has been armed and then disarmed by adding the
9
button to the end of the user code
before exit time has expired, a "Duress" report will be transmitted). Adding
9
to the end of a
user code when arming the system will not cause a duress alarm.
Refer to Option 2 in “LOCATION 430” on page 221 if you wish to add the 3 button the end of
the user code being used to disarm the system in a duress situation.
Restore reports are not transmitted for this event. If a "Duress" report is not required,
program "LOCATION 336" with a zero.
Codepad Panic Report
LOCATION 337 - 338
7
Location Description
337
Codepad Panic Reporting Code (Tens Digit)
338
Codepad Panic Reporting Code (Units Digit)
Table 87: Codepad Panic Report Locations
A "Panic Alarm" report (Contact ID Event Code 120) will be transmitted to the base station
receiver when either the two outside buttons
1
and
3
or and are pressed
simultaneously. This is an audible alarm. Refer to Option 1 in "LOCATION 425" on page
216 if you require codepad panic to be silent.
Restore reports are not transmitted for this event. If a "Panic" report is not required,
program "LOCATION 337 - 338" with a zero.
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
