EDM Solution 862 - Codepad Buzzer Tone Change

110
Solution 862
Installation Manual
8
Codepad Buzzer Tone Change
Holding the
8
button down continuously will change the tone of the buzzer in the remote
codepad. There are fifty different tones to choose from between 1500 Hz - 5000 Hz and they
are specific to each codepad. In a multiple codepad installation, each codepad can have a
different tone.
How To Change The Tone Of The Buzzer
1.
To change the tone of the codepad buzzer, hold the
8
button down continuously.
The tone of the buzzer will start to increase in pitch.
2.
Release the
8
button when the desired tone has been reached.
Every time the system has been powered down, each codepad will need their individual
tone reset using this function.
Send Test Report
9
Holding the
9
button down until two beeps are heard will transmit a test report (Contact ID
Event Code 602) that is used to test the dialling and reporting capabilities of the system
without causing the sirens to sound.
A test report will not be transmitted if the Subscriber ID Number is 0000. This feature is only
applicable if the control panel has been programmed to report via the telephone.
ISSUE130 Electronics Design and Manufacturing Pty Limited