Telco Disarming Sequence
LOCATION 143 – 158
0000000000000000
These locations allow you to automatically deactivate call diversion on your telephone when
you disarm the system from AWAY Mode.
Digit Required Number To Program Digit Required Number To Program
0
10
8
8
1
1
9
9
2
2
10
10
3
3
*
11
4
4
#
12
5
5
Four Second Pause
13
6
6
Break
14
7
7
15
15
Table 60: Telco Arm/Disarm Dialling Digits
Telco Arming – Call Forward Immediate Off
To turn Call Forward Immediate Off:
#21#
Example
If you wish to disable the Telco Arming – Call Forward Immediate upon disarming the system
from AWAY Mode, you would program the following:
21 000000000000
Telco Arming – Call Forward No Answer Off
To turn Call Forward No Answer Off:
#61#
Example
If you wish to the Telco Arming – Call Forward No Answer upon arming the system from
AWAY Mode, you would program the following:
61 000000000000
Call Back Telephone Number
LOCATION 159 - 174
0000000000000000
This location contains the telephone number that will be called when Upload/Download is
requested or the number
6
button is held down to initiate a modem call from the control panel
to establish a communications link with the remote computer. The computer must be running
the Alarm Link Software (CC816) and will need to be set to "Waiting For An Incoming Call".
The Call Back Telephone Number is also required to be programmed if Remote Connect With
Call Back Verification on page 115 is required.
Refer to the section - Alarm Link Operations beginning on page 113 for more information.
Dialler Information 139
Electronics Design and Manufacturing Pty Limited ISSUE130
To Next Page
Loading...
