104
Solution 862
Installation Manual
6
Setting The Date and Time
This function only needs to be used when the date and time requires to be changed or the
system has been powered down.
If the date and time has not been set using this function, the date and time fault will only
display when the Auto Arming Time in “LOCATION 414 - 417” on page 208 has been
programmed, or when you enter Fault Analysis Mode by holding down the
5
button.
How To Set The New Date and Time
1.
Enter your
followed by
6
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
2.
Enter the day, month, year, hour and minute using the (DD, MM, YY, HH, MM) format
(i.e. DD = Day of the month, MM = Month of the year, YY = Current year, HH = Hour
of the day, MM = Minute of the day).
Please note that when programming the hour of the day, you will need to use 24:00 hour
format.
3.
Press the
button when finished.
Two beeps will be heard and the
STAY
and
AWAY
indicators will extinguish. If a long
beeps is heard, an error was made when entering the date and time.
+
6
+
DD
+
MM
+
YY
+
HH
+
MM
+
Example
If the date and time needs to be set for the 1st January 1997 at 10:30 PM, program the date and
time as follows;
2580
+
6
+
0
+
1
+
0
+
1
+
9
+
7
+
2
+
2
+
3
+
0
+
ISSUE130 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
