EDM Solution 862 - Page 93

System Functions 93
How To Delete A Remote Radio User Code
1.
Enter your followed by
1
and the button.
Three beeps will be heard and the
STAY
and
AWAY
indicators will begin to flash.
2.
Enter the
(9-16) that you wish to delete followed by the button.
Two beeps will be heard and the corresponding
ZONE
indicator will illuminate. Refer
to "Table 36: Codepad Indicators Showing Relative Remote User Numbers" on page 93.
3.
Press the
button to delete the user code.
Two beeps will be heard and the
STAY
and
AWAY
indicators will extinguish.
If you wish to delete any further remote radio user codes, repeat this procedure as many
times as required.
+
1
+
+ + +
When deleting remote radio user codes, this function will automatically terminate if a
button is not pressed within sixty seconds or by pressing the button. One long
beep indicates the an incorrect user number has been selected.
User
No
Zone 1
Indicator
Zone 2
Indicator
Zone 3
Indicator
Zone 4
Indicator
Zone 5
Indicator
Zone 6
Indicator
Zone 7
Indicator
Zone 8
Indicator
MAINS
Indicator
9
V V
10
V
11
V V
12
V V
13
V V
14
V V
15
V V
16
V V
Table 36: Codepad Indicators Showing Relative Remote User Numbers
Electronics Design and Manufacturing Pty Limited ISSUE130